fereocean.blogg.se - Dsc alarm panel instructions

#DSC ALARM PANEL INSTRUCTIONS INSTALL#
#DSC ALARM PANEL INSTRUCTIONS CODE#
#DSC ALARM PANEL INSTRUCTIONS PASSWORD#

At this point you have verified that your control panel is successfully communicating with and that alarm signals are being forwarded to the central station. Check to see if your history shows the alarm signals from testing. Log into your account using the information in your Welcome Letter and verify your email address.

If you do not have 24/7 monitoring, alarm signals can instead be verified by logging into and viewing the activity page.

#DSC ALARM PANEL INSTRUCTIONS PASSWORD#

If you do not receive a call within 1 minute of sending the alarm signal, call the central station ( 85) to find out whether the signals failed to go through, or whether there is a problem with the call list they have on file (be prepared to give them your password to verify there has been no real alarm), then visit the forum for technical support. Answer the phone and give the operator the Emergency Password from your contract. If you are NOT on test mode, wait for the central station operator to call you. If you’re ready, you can then have them remove test mode. If your account is on test mode, you’ll need to call the central station to verify that the signals were received.

#DSC ALARM PANEL INSTRUCTIONS CODE#

After the alarm sounds then you can enter your master code to cancel the alarm and your control panel should tell you that the alarm signal was already sent. Arm your system and then trigger an alarm by opening a door and not entering your master code to disarm. Make sure you are in a position to answer the phone number you chose for your Emergency Call List and make sure you know your Emergency Password on your agreement before going forward if you have 24/7 monitoring. Press to broadcast sensor names (labels). To broadcast sensor names using the keypad:

#DSC ALARM PANEL INSTRUCTIONS INSTALL#

This should be done for every install with an LCD keypad and is necessary even if there is only one keypad on the system.

For the SEM to be able to read the sensor names stored on the panel and display them on, you must broadcast the sensor names stored on the keypads.

The date and time will show on the screen when the zone scan is complete. If you press any buttons on the keypad during the zone scan, the message System unavailable will display on the screen. The zone scan is complete when the green and yellow lights on the keypad remain solid. Do not touch the panel, keypad, or SEM at this time.

The zone scan will automatically begin after the panel is powered up and should take about 5-15 minutes.The SEM will do a “zone scan” to read this information. For the SEM to interact with the existing zones on the system, it must read them from the PowerSeries panel. Connect the backup battery and restore AC power to the panel.Following the diagram below, you can begin wiring your SEM to your existing Control Panel.Be sure to unplug both AC Transformer and Back-up Battery for your Main Control Panel prior to making wire connections or you could risk damage to your panel or module!.SuretyDIY System Enhancement Module Setup Instructions Installation of the SEM